Current Rating
3 amperes max
Contact Resistance
8 milliohms max at
.5 to 3 amperes
12 milliohms max at
10 microamperes
Contact Engagement Force
6 oz. max, 2.9 oz. average
Contact Separating
0.5 oz. min, 2.0 oz. average
Force
Dielectric Withstanding
600 VAC @ Sea Level
Voltage
150 VAC @ 70,000 ft.
Durability
No mechanical or electrical defects after 2000 cycles of mating and unmating
Temperature Range
Polyester, Polyphenylene Sulfide, Nylon and ULTEM
–55ºC to +125ºC
Physical Shock
1 shock in each direction
of 3 major axis per Method
2004 Test Cond. E of MIL- STD 1344. No breakage
or discontinuities.
Contact Retention
5 lb. minimum axial load.
Vibration
No breakage or discontinuities when
tested per Method 2005
Test Cond. IV or MIL-STD 1344.
Salt Spray
48 hours per Method 1001
Cond. B of MIL-STD 1344. No resultant corrosion or conditions detrimental to the connector operation.
Insulation Resistance
5000 Megohms min. when tested per Method 3003 of MIL-STD 1344.
Magnetic Permeability 2.0µ maximum when measured with instrumentation conforming to MIL-I-17214 (unmated, no current flow).
Humidity
Per Method 1002, Type II of MIL-STD 1344, omitting Steps 7a and 7b. Insulation resistance greater than one megohm @ 100 VDC.
Cancellations
All orders placed are considered to be firm and can be
manufactured at any time for cost efficiency unless otherwise specified by the Customer at time
of quotation and/or order placement. Cancellation charges will be applicable on all work inprocess
operations and material ordered to manufacture connectors purchased. An additional
$75.00 cancellation fee applies for paperwork handling.
Conditions
The prices and terms on this quotation are not subject to verbal changes or other
agreements unless approved in writing by an authorized representative of Min-E-Con LLC.
· All quotations and agreements are contingent upon strikes, accidents, fires, availability of
materials and all other causes beyond our control.
- Typographical and stenographic errors are subject to correction.
- Purchaser agrees to accept either overage or shortage not in excess of ten percent to be
charged for pro-rata. - Purchaser assumes liability for patent and copyright infringement when goods are made to
Purchaser’s specifications. - When quotation specifies material to be furnished by the Purchaser, ample allowance must
be made for reasonable spoilage and material must be of suitable quality to facilitate efficient
production. - Conditions not specifically stated herein shall be governed by established trade customs.
- Terms inconsistent with those stated herein which may appear on Purchaser’s formal order
will not be binding to Min-E-Con LLC.
Rescedule
There will be an additional $75.00 rescheduling fee for all orders subject to
reschedule within Min-E-Con’s issue period or on completed orders ready for shipment.
Warranty
It is expressly agreed that this warranty shall be in lieu of all warranties of fitness
and in lieu of the warranty of merchantability.
Notice of any defect must be received by seller within 90 days of the date of shipment of the
goods; in the absence of such timely notice, it shall be conclusively presumed the goods are free
from defect and Min-E-Con LLC will incur no liability as to such goods sold to Purchaser and
upon receipt of such goods from Purchaser, shipment prepaid, and after examination and
satisfaction that such defect did not arise as a result of misuse, neglect, improper installation,
repair alteration or accident. In no event shall Min-E-Con be liable for collateral or consequential
damages.